How to Setup the HS2 Manual Stand - Red Light Hero

How to Setup the HS2 Manual Stand

First published
Last updated

In short

A short video showing how to assemble the HS2 Manual Stand™ and mount up to four panels on it.

After a few customers asked for guidance on how to setup the HS2 Manual Stand, we decided to make a video tutorial with step by step instructions to set it up for holding up to 4 panels vertically.

Watch it on our Instagram:

About the author

Helmut Uhlmann

Helmut Uhlmann

Founder, Red Light Hero

Helmut Uhlmann founded Red Light Hero and writes this blog. He delves deep into the research and is passionate about helping people get the most out of red light therapy.

Our story

Speak to us

Questions about this article, or about which device fits what you want to do? Email us or leave a comment. Advice is complimentary and there is no obligation to buy anything.

Disclaimer

Red Light Hero devices use clinical-grade LEDs but are not included in the ARTG and are not intended to treat or prevent disease. The research discussed here is about the wavelengths and technologies we use, not about our products. This article is educational information only, not medical advice - check with your healthcare professional before use, particularly if you are pregnant, take medication that increases light sensitivity, or have a condition affecting your eyes or skin.

Leave a comment

Please note, comments need to be approved before they are published.

Back to blog